How do you reset uconnect

Earlier today my system locked up. It would not boot up. I called UConnect. Ut they were unable to figure out how to do so. They transferred me to the Sirius folks who did not know either. They just told me to take it to my local service dept. I can find info online about resetting earlier models, but nothing on this. Thanks for any suggestions. Unhook the negative battery cable and leave it off for 10 minutes then reconnect.

Thanks very much. Appreciate it. Twoamen Well-Known Member. Did battery disconnect work. I read a forum said it had internal battery backback. Twoamen said:. Click to expand Jkurtz said:. I did not have to try. After turning the car off and leaving it for about a half-hour, it started working again. Jared B Site admin Staff member. Hold the volume and tune buttons with the truck running until the system reboots itself to do a soft reset. Where did you get that from? Does not seem to work.

YoAdrian Moderator Staff member. Site Supporter. That's the way it worked for the older 8. I've posted that before for a few other members with the To reset the Jeep Grand Cherokee radio, hold down the two dial buttons for ten seconds. You will come into problems with the sound. Try pulling it for 10 seconds. Pull it out for 30 seconds then put it back in. As mentioned, you can pull the fuse or just wait about 5 minutes with the jeep turned off and it will shut off. After this time has passed the screen will flash and then it should come back on and work like normal.

Once this report has been filed, Uconnect Care can help locate your vehicle. Then, using GPS technology and the built-in wireless connection within your vehicle, the Uconnect Care Agent will be able to locate the stolen vehicle and work with law enforcement to help recover it. Generally map updates are released every months. Our most current map update was released December Afterwards, close the driver's door. Allow the Journey's media screen to load refreshed digital settings.

The Journey's Uconnect system should be restored. Other options include disconnecting the battery cables for minutes. Re-connect and follow prompts to re-load Uconnect.